How do I install the Plastic Speed Reducer (Face Plate)?
# Remove all attachments from the machine and unscrew knobs at end of latching arms.
# Carefully peel off "TWIN GEAR" sticker ( for Green Power Juicer only).
# Unscrew 2 small screws in each latching arm, be careful not to lose any (for Green Power Juicer only).
# Unscrew 3 or 4 screws in face place.
# Pull out old face plate. (Please observe how the latching arms are positioned in the motor front plate and the flat side of the latching arms face outside)
# Remove bushing (white and orange color) from old face plate by pushing it out of the face plate.(this is the part that the "male" gear fits into)
# Position bushing onto motor. Line up the bushing with the appropriate groove.
# Check that all seals are installed? Clean up motor shaft if necessary. Slightly grease drive shaft.
# Install face plate by following above instructions in reverse order.
Can't find the answer to your question? See all FAQs OR Ask us
| 
